Practice Design Of Simply Supported Beams Using Rolled Steel Sections (3)

Practise this section

9 questions

Flashcard drill
3 cards from this section. Quick, good the night before a test.
Exercise
6 questions · about 4 min · pass mark 70%. Hints available.
Sign up to start the exercise
Quiz
3 questions · about 2 min · pass mark 70%. Hints available.
Sign up to start the quiz

6 sample questions

Question 1.
Define a simply supported beam.
Show hintHide hint
Think about how it behaves under loads.
Question 2.
What does the term deflection refer to in beam design?
Show hintHide hint
Consider how far a beam bends under weight.
3Question 3.
What is a simply supported beam?
- A beam fixed at both ends
- A beam with supports at both ends
- A beam that cannot rotate
Show hintHide hint
Think about how its supports behave.
4Question 4.
True or False: Dead loads are temporary loads that change over time.
- True
- False
Show hintHide hint
Consider the nature of these loads.
Question 5.
Design a simply supported beam with a span of 7 m. The total load is 20 kN/m, including dead and live loads. Calculate the required section modulus.
Show hintHide hint
Review the formulas for bending moment and section modulus.
Question 6.
Evaluate the deflection of a simply supported beam with a span of 6 m under a uniform load of 10 kN/m. Suggest ways to reduce the deflection.
Show hintHide hint
Consider factors affecting deflection, like the moment of inertia.

5 more questions in this section. Enroll free to practise them all.