Practice Fault Models In Electronic Systems (3.2) - Fault Models, Testing Methodologies, and Industry Standards

Practise this section

10 questions

Flashcard drill
2 cards from this section. Quick, good the night before a test.
Exercise
6 questions · about 4 min · pass mark 70%. Hints available.
Sign up to start the exercise
Quiz
4 questions · about 3 min · pass mark 70%. Hints available.
Sign up to start the quiz

6 sample questions

Question 1.
What is a stuck-at fault?
Show hintHide hint
Think about how a switch might be permanently stuck.
Question 2.
Give an example of a bridging fault.
Show hintHide hint
Consider what might happen if rubber insulation wears off.
3Question 3.
What is a stuck-at fault?
- A fault where a signal is disconnected
- A fault where a signal is fixed at a logic level
- A fault caused by thermal issues
Show hintHide hint
Think of how a light switch might stay on or off.
4Question 4.
True or False: Bridging faults are caused by improper soldering.
- True
- False
Show hintHide hint
Consider poor manufacturing conditions.
Question 5.
Design a simple circuit that includes a stuck-at fault and explain how you would test for it.
Show hintHide hint
Think of how to build a testing sequence.
Question 6.
Assume you have a circuit with both bridging and delay faults. How would you prioritize testing them?
Show hintHide hint
Consider the impact on performance during tests.

6 more questions in this section. Enroll free to practise them all.