Practice Post-processing (6.3) - Engineering Analysis - Computer Aided Design & Analysis

Practice: Post-processing

Lesson 6.3Engineering Analysis

Practise this section

10 questions

Flashcard drill
3 cards from this section. Quick, good the night before a test.
Exercise
6 questions · about 4 min · pass mark 70%. Hints available.
Sign up to start the exercise
Quiz
4 questions · about 3 min · pass mark 70%. Hints available.
Sign up to start the quiz

6 sample questions

Question 1.
What is the primary objective of post-processing in FEA?
Show hintHide hint
Think about what we do with results after completing simulations.
Question 2.
Name one type of visualization technique used in post-processing.
Show hintHide hint
Consider the ways we can graphically represent data.
3Question 3.
What is the main purpose of post-processing in FEA?
- To ignore results
- To analyze and visualize results
- To mess with data
Show hintHide hint
Remember the discussion about what we do after simulations.
4Question 4.
True or False: Validation of your results helps in assessing the accuracy of your FEM model.
- True
- False
Show hintHide hint
Think about why we check our results.
Question 5.
You have conducted an FEA on a beam under bending load. The maximum stress obtained through FEA is 250 MPa, while experimental measurements show a maximum of 300 MPa. Discuss the potential reasons for this discrepancy and steps to validate your model.
Show hintHide hint
Think about how you would debug your analysis.
Question 6.
Create a structured outline for a post-processing report highlighting significant results and any recommendations based on keyword findings. What should be the emphasis in your report's introduction?
Show hintHide hint
Consider who will read your report and what they need to know.

6 more questions in this section. Enroll free to practise them all.