Practice Quality Control And Acceptance Criteria (4.12) - Compressive Strength Test

Practice: Quality Control and Acceptance Criteria

Lesson 4.12Compressive Strength Test

Practise this section

10 questions

Flashcard drill
3 cards from this section. Quick, good the night before a test.
Exercise
6 questions · about 4 min · pass mark 70%. Hints available.
Sign up to start the exercise
Quiz
4 questions · about 3 min · pass mark 70%. Hints available.
Sign up to start the quiz

6 sample questions

Question 1.
What does destructive testing measure in concrete?
Show hintHide hint
Think about what happens to concrete during testing.
Question 2.
Can an individual test result for concrete strength be less than the characteristic strength?
Show hintHide hint
Recall what the acceptance criteria state.
3Question 3.
What is the primary purpose of destructive testing?
- To measure strength characteristics
- To increase concrete density
- To evaluate color changes
Show hintHide hint
Consider how tests are carried out!
4Question 4.
True or False: Individual test results for concrete must always exceed the characteristic strength.
- True
- False
Show hintHide hint
Review the acceptance standards for concrete!
Question 5.
Given a batch of concrete cube tests with an average compressive strength of 30 MPa and an individual test result of 3 MPa, analyze the implications of these results on project quality control.
Show hintHide hint
Consider how individual tests contribute to acceptance.
Question 6.
A project specifies that concrete must exhibit a compressive strength of 25 MPa. After testing, you observe an average of 22 MPa with individual tests showing one at 20 MPa. What decisions should be taken?
Show hintHide hint
Ensure compliance with all criteria discussed.

6 more questions in this section. Enroll free to practise them all.