Practice Details Of One-way Continuous Slab For A Hall (11.6) - Exercises in Computer Aided Building Planning and Drawing (BCV305)

Practice: Details of One-way Continuous Slab for a Hall

Lesson 11.6Exercises in Computer Aided Building Planning and Drawing (BCV305)

Practise this section

8 questions

Flashcard drill
3 cards from this section. Quick, good the night before a test.
Exercise
6 questions · about 4 min · pass mark 70%. Hints available.
Sign up to start the exercise
Quiz
2 questions · about 1 min · pass mark 70%. Hints available.
Sign up to start the quiz

6 sample questions

Question 1.
What are the dimensions of the slab being designed?
Show hintHide hint
Refer to the context of the slab.
Question 2.
What is the thickness of the one-way slab?
Show hintHide hint
It's indicated in the specifications of the slab.
3Question 3.
What is the total thickness of the slab discussed?
- 100mm
- 150mm
- 200mm
Show hintHide hint
Relate it back to the structural specifications.
4Question 4.
True or False? Positive reinforcement is used primarily at supports.
- True
- False
Show hintHide hint
Consider where tensile stresses primarily occur.
Question 5.
Design a one-way slab for a hall with dimensions 12m by 18m. Specify the reinforcement needed considering a total load of 15kN/m2.
Show hintHide hint
Consider both span and load during your calculations.
Question 6.
Analyze the failure mechanism if the negative reinforcement is omitted at the supports of a 10m long continuous slab.
Show hintHide hint
Think about the tension forces acting on the support areas.

4 more questions in this section. Enroll free to practise them all.