Practice Aligned Dimensions (dimaligned Command) (4.2.2) - Module 4: Annotation and Dimensioning

Practice: Aligned Dimensions (DIMALIGNED Command)

Lesson 4.2.2Module 4: Annotation and Dimensioning

Practise this section

8 questions

Flashcard drill
2 cards from this section. Quick, good the night before a test.
Exercise
6 questions · about 4 min · pass mark 70%. Hints available.
Sign up to start the exercise
Quiz
2 questions · about 1 min · pass mark 70%. Hints available.
Sign up to start the quiz

6 sample questions

Question 1.
What does the DIMALIGNED command do in AutoCAD?
Show hintHide hint
Think about how ramps or sloped surfaces are measured.
Question 2.
Name one scenario where you would use the DIMALIGNED command.
Show hintHide hint
Consider designs that have slopes.
3Question 3.
What is the primary purpose of the DIMALIGNED command?
- To measure horizontal lines
- To measure inclined distances
- To draw straight lines
Show hintHide hint
What do you think it measures based on its name?
4Question 4.
True or False: The DIMALIGNED command can only be used for horizontal lines.
- True
- False
Show hintHide hint
Think about the name of the command.
Question 5.
You have a design that includes a ramp with a 30-degree tilt. Using the DIMALIGNED command, how would you document the slope of this ramp properly?
Show hintHide hint
Consider first how to identify start and end points.
Question 6.
Draft a small architectural plan highlighting the use of the DIMALIGNED command for various inclined surfaces and justify your dimension choices.
Show hintHide hint
Think about the practical implications of the dimensions.

4 more questions in this section. Enroll free to practise them all.